| Removal and Installation Removal All vehicles | | -
Detach the audio remote control from the steering column lower shroud (if equipped). - Using a thin bladed screwdriver, release the locking tang.
| | | -
Remove the audio remote control (if equipped). - Disconnect the electrical connector.
| | | -
NOTE:Turn the steering wheel to gain access to the steering column upper shroud retaining clips. Detach the steering column upper shroud (steering wheel shown removed for clarity). - Using a thin bladed screwdriver, release the two clips, (one each side).
| | | -
Remove the steering column lower shroud (steering wheel shown removed for clarity). - Remove the retaining screws.
- Release the steering column locking lever.
| | | -
Disconnect the passive anti-theft (PATS) transceiver electrical connector. | | | -
Remove the PATS transceiver (steering column multifunction switch shown removed for clarity). - Release the locking tangs.
| | | -
Turn the ignition key to position 1. | Left-hand drive vehicles | | -
Remove the ignition lock cylinder. - Depress the detent in the housing and pull out the cylinder.
| Right-hand drive vehicles | | -
Remove the ignition lock cylinder. - Depress the 2 detents at the top and bottom of the housing and pull out the cylinder.
| Installation | | -
To install, reverse the removal procedure. | |
