ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3242 > < Initial Inspection and Diagnostic Overview|Page 3240
Page 91
background image

-

Are the resistances less than 5 ohms?

Yes

CONNECT the negative battery cable. GO to AC61. 

No

REPAIR the circuit in question. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.

-------------------------------------------------
AC9 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER

 

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to AC11. 

No

GO to AC10.

-------------------------------------------------
AC10 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR AN OPEN

 

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance greater than 10,000 ohms?

Yes

REPAIR the circuit in question. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool. 

Initial Inspection and Diagnostic Overview|Page 3242 > < Initial Inspection and Diagnostic Overview|Page 3240