| Removal and Installation Removal | | -
Remove the instrument cluster glass. | | | -
Release the tang and disconnect the electrical connector. | | | -
Remove the Torx retaining screws and remove the speedometer. | | | -
Remove the Torx retaining screw and remove the temperature gauge. | | | -
Remove the Torx retaining screw and remove the fuel gauge. | | | -
Remove the electrical connector surrounds. - Push out the centre of the retainers from the front of the instrument cluster.
- Remove the bulbs from the printed circuit.
| | | -
Push the sides of each connector towards the centre to release (do not push all the way through) and remove bulbs. | | | -
Release the circuit board carefully from its locating dowels and remove. | Installation | | -
Refit the components in reverse order. | | |
