General Procedures WARNING:The window anti-trap function will not operate during the window motor initialization procedure. NOTE:Make sure that the window runs are correctly installed and free of foreign material. NOTE:If the power to a window regulator motor has been disconnected, that window regulator motor must be initialized. NOTE:Wait for a minimum of 1 minute before connecting the battery, fuse or electrical connector. | -
Press and hold the power window control switch close button until the door window is fully closed. | | -
Release the power window control switch close button. | | -
Press the power window control switch close button three times for one second. | | -
Briefly press the power window control switch open button to the 2nd detent and release the button. The door window should open automatically. | | -
Briefly press the power window control switch close button to the 2nd detent and release the button. If the door window does not close automatically, repeat the complete procedure. | | -
Repeat the door window motor initialization for each door window motor. | |