ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Fuel Pressure Regulator > < Fuel Injection Supply Manifold

Puma 1998 (06.1997-12.2001)

Fuel Charging and Controls - Fuel Injectors Puma 1998 (06/1997-12/2001)
Removal and Installation

Removal

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to follow these instructions may result in personal injury.
  1. Remove the supply manifold.
    For additional information, refer to Supply Manifold-Fuel in this section.

  1. Remove the fuel injectors.

Installation

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to follow these instructions may result in personal injury.
  1. Install new O-ring seals.

  1. NOTE:
    NOTE:Lubricate the seals with clean engine oil to aid installation.
    To install, reverse the removal procedure.

Fuel Pressure Regulator > < Fuel Injection Supply Manifold