ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Mass Air Flow (MAF) Sensor > < Camshaft Position (CMP) Sensor

S-MAX.Galaxy 2006.5 (03.2006-)

Electronic Engine Controls - 2.5L Duratec (VI5) - Powertrain Control Module (PCM) S-MAX/Galaxy 2006.5 (03/2006-)
Removal and Installation

General Equipment
3.5 mm drill bit
Center punch
Ford diagnostic equipment

Removal

NOTE:
NOTE:Removal steps in this procedure may contain installation details.
  1. NOTE:
    NOTE:This step is only necessary when installing a new component.
    Download the PCM and throttle body configuration information into the diagnostic tool, using the Programmable Modules Installation routine.
    General Equipment: Ford diagnostic equipment
  1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
Vehicles without PCM security shield

  1. Torque: 7 Nm
Vehicles with PCM security shield
  1. Refer to: Air Cleaner (303-12 Intake Air Distribution and Filtering - 2.5L Duratec-ST (VI5), Removal and Installation).

  1.  
    1. General Equipment: Center punch
    1. General Equipment: 3.5 mm drill bit

Installation

  1. To install, reverse the removal procedure.
Vehicles with PCM security shield
  1. Tighten the shear bolt until the head is sheared off.
All vehicles
  1. NOTE:
    NOTE:This step is only necessary when installing a new component.
    Upload the PCM and throttle body configuration information into the PCM, using the Programmable Modules Installation routine.
    General Equipment: Ford diagnostic equipment

Mass Air Flow (MAF) Sensor > < Camshaft Position (CMP) Sensor