| Removal and Installation Special Tool(s) | | Aligner, Clutch Plate 308-204 (16-067) | Materials Name Specification Grease ESD-M2C220-A Removal | | -
Remove the transmission. For additional information, refer to: Transmission (308-03C, Removal). | | | -
CAUTION:Loosen the clutch pressure plate retaining bolts by two turns at a time in the sequence shown. Remove the clutch disc and pressure plate. | Installation | | -
Using the special tool, centralize the clutch disc on the pressure plate. | | | -
Check the pilot bearing for damage. If damaged, install a new pilot bearing.
For additional information, refer to: Pilot Bearing (308-01 Clutch - Vehicles With: MT-75, Removal and Installation).
| | | -
NOTE:Do not apply grease to a newly installed pilot bearing. Apply approximately one gram of grease to the pilot bearing. | | | -
CAUTION:Tighten the clutch pressure plate retaining bolts finger tight and then by two turns at a time in the sequence shown to the specified torque. Using the special tool, install the clutch disc and pressure plate. | | | -
Apply a thin film of grease to the input shaft guide sleeve. | | | -
Install the transaxle.
For additional information, refer to: Transmission (308-03C, Installation).
| | |
