| Removal and Installation Name Specification Gasket Eliminator Sealant WSK-M2G348-A5 High Temperature Grease ESDM-1C220-A Removal NOTE:Whenever the clutch slave cylinder and release bearing assembly is removed, a new one must be installed. | | -
Remove the transaxle.
For additional information, refer to: Transaxle (308-03B Manual Transmission/Transaxle - Vehicles With: VXT-75, Removal).
| | | -
Clean any grease and foreign material from the input shaft. | | | -
CAUTION:If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. CAUTION:Using suitable adhesive tape, cover the input shaft splines to prevent damage to the input shaft oil seal. Remove the clutch slave cylinder and release bearing assembly. - Discard the clutch slave cylinder and release bearing assembly.
| Installation | | -
Apply sealant to the mating faces of the clutch slave cylinder and release bearing assembly and the transaxle housing. | | | -
CAUTION:If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. CAUTION:Do not apply grease on any area of the clutch slave cylinder. NOTE:Install a new clutch slave cylinder and release bearing assembly. Install the clutch slave cylinder and release bearing assembly. | | | -
Remove the adhesive tape from the input shaft splines. | | | -
Install the transaxle.
For additional information, refer to: Transaxle (308-03B Manual Transmission/Transaxle - Vehicles With: VXT-75, Removal).
| | |
