| Removal and Installation Removal | | -
Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
Remove the seat height adjust levers. | | | -
Remove the seat outer trim panel. | | | -
WARNING:The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected. Wait 3 minutes before disconnecting or removing any SRS components. WARNING:Do not probe supplemental restraint system (SRS) electrical connectors. WARNING:Always carry a live air bag module away from the body with the air bag or trim cover pointed away from the body. Disconnect the heated seat and side air bag module electrical connectors (if equipped). | | | -
Detach the safety belt lower anchor from the seat. | | | -
Move the seat fully rearwards. | | | -
Remove the seat front retaining bolts. | | | -
Move the seat fully forwards. | | | -
Remove the rear retaining bolts and remove the seat. | Installation | | -
To install, reverse the removal procedure. | | |
