| Removal and Installation Removal WARNING:To avoid accidental deployment, the air bag control module backup power supply must be depleted. Wait at least one minute after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors. Failure to follow these instructions may result in personal injury. WARNING:Always wear safety glasses when working on an air bag equipped vehicle and when handling an air bag module. Failure to follow this instruction may result in personal injury. WARNING:To minimize the possibility of premature deployment, do not use radio key code savers when working on the SRS. Failure to follow this instruction may result in personal injury. WARNING:Never probe the electrical connectors of air bag modules or any other SRS component. Failure to follow this instruction may result in personal injury. | | -
Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
Remove the B-pillar trim panel.
For additional information, refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
| | | -
Disconnect the safety belt retractor and pretensioner electrical connector. | | | -
Remove the safety belt retractor and pretensioner. - Remove the safety belt retractor and pretensioner retaining bolt.
- Lift the safety belt retractor and pretensioner to detach the locating tang.
| Installation WARNING:Always wear safety glasses when working on an air bag equipped vehicle and when handling an air bag module. Failure to follow this instruction may result in personal injury. WARNING:Never probe the electrical connectors of air bag modules or any other SRS component. Failure to follow this instruction may result in personal injury. | | -
CAUTION:Make sure that the safety belt retractor and pretensioner locating tang is correctly located. NOTE:Make sure that the safety belt shoulder height adjuster locking control is correctly located on the safety belt shoulder height adjuster. To install, reverse the removal procedure. | | 
