K Yukon/Denali 4WD V8-5.7L VIN R (2000)
1. Using the J 36618 and the J 9519-23, install the front bushing.
-
This applies to the K3 vehicle only.
-
After installing the bushing, crimp the bushing in place.
2. Using the J 36618 and the J 9519-23, install the rear bushing.
3. Install the lower control arm and the knuckle assembly to the crossmember and the frame bracket. Install the front leg of the lower control arm into
the crossmember before installing the rear leg into the frame bracket.
4. Install the bolts in the direction shown.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Tighten the nuts with the control arm at the proper Z height. Refer to Trim Height Inspection Procedure in Suspension General
Diagnosis.
-
Tighten the front nut prior to tightening the rear nut.
5. Install the new nuts.
-
Tighten the nuts to 165 Nm (121 ft. lbs.).
6. Prelube the steering knuckle seal.
7. Start the drive axle through the hub.
8. Connect the ball joint to the knuckle.
9. Install the ball joint nut.
-
Tighten the nut to 128 Nm (94 ft. lbs.).
10. Install the cotter pin. Bend the pin ends against the side of the nut.
11. Install the torsion bar adjuster arm.
