Accord V6-3.0L Hybrid (2005)
9. Remove the bolt, then remove the spacer (A).
10. While pulling the outer handle (A), remove the handle from the holes in the door panel. Take care not to scratch the door.
11. Install the handle in the reverse order of removal, and note these items:
-
Make sure the lock cylinder switch harness is routed properly.
-
Make sure the lock cylinder switch connector is plugged in properly, and each rod is connected securely.
-
Be sure that the end of the lock cylinder is engaged with the lock cylinder switch correctly.
-
Make sure the door lock cylinder/door locks operate properly.
-
Make sure the door handle works properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal cut water.
-
Driver's: Perform the power window control unit reset procedure.
