CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
4. Install new boot bands on the small ends of the boots, and bend both sets of locking tabs on bands.
5. Lightly tap on the doubled-over portions to reduce their height.
6. Install the spider on the driveshaft by aligning the mark on the spider with the mark on the end off the driveshaft.
7. Install a new circlip into the end groove on the driveshaft. Rotate the circlip in its groove to be sure its fully seated.
8. Reinstall the rollers in their original positions on the spider by aligning the marks. After installation, be sure to hold the driveshaft pointed straight
up to prevent the rollers from falling off.
