S2000 L4-2.2L (2004)
5. Carefully clamp the driveshaft in a vise.
6. Remove the outboard joint (A) using the special tool and a commercially available 5/8" x 18 slide hammer (B).
7. Remove the driveshaft from the vise.
8. Remove the stop ring from the driveshaft.
9. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damage to the boot.
10. Remove the outboard boot and boot band (B). Take care not to damage the boot.
11. Remove the vinyl tape.
Reassembly
Special Tools Required
^
Boot band tool, KD-3191 or equivalent, commercially available
^
Boot band pincers, Kent-Moore J-35910 or equivalent, commercially available
NOTE: Refer to the Exploded View as needed during this procedure.
Inboard Joint Side:
