S2000 L4-2.2L (2004)
1. Wrap the splines with vinyl tape (A) to prevent damage to the inboard boot.
2. Install the inboard boot to the driveshaft, then remove the vinyl tape. Take care not to damage the inboard boot.
3. Install the spider (A) onto the driveshaft (B) by aligning the marks (C) on the spider and the end of the driveshaft.
4. Fit the circlip (D) into the driveshaft groove. Always rotate the circlip in its groove to make sure it is fully seated.
5. Fit the rollers (A) onto the spider (B) as shown, and note these items;
^
Reinstall the rollers in their original positions on the spider by aligning the marks (C).
^
Hold the driveshaft pointed up to prevent the rollers from falling off.