Veracruz FWD V6-3.8L (2009)
6. Remove the trunnion assembly (B) from the driveshaft (A) using the special tool (09495-33000).
7. Clean the trunnion assembly.
8. Remove the boot (A) of the transaxle side joint(TJ).
CAUTION:
For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).
9. Using a plier or flat-tipped (-) screwdriver, remove the clamp on the side of wheel.
10. Pull out the joint(BJ) on the side of wheel into the transaxle direction.
Be careful not to damage the boot.
Reassembly
1. Wrap tape around the driveshaft splines (TJ. side) to prevent damage to the boots.
2. Apply grease to the driveshaft and install the BJ boots.
