Rodeo S 2WD L4-2.2L (1999)
Valve Cover: Service and Repair
Removal and Installation (2)
Cylinder Head Cover And Associated Parts
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect PCV hose from cylinder head cover.
3. Remove intake duct.
4. Remove left side ground cable from cylinder head cover and disconnect ground cable connector on the left side wheel arch. Remove right side
ground cable from generator stay and disconnect ground cable connector on the right side wheel arch.
5. Disconnect three (black, green and blue colors) engine wire harness connectors from chassis harness of left rear side of compartment.
6. Disconnect cooling fan wire harness connector from cooling fan on left side top of fan shroud.
7. Move drive belt tensioner to loose side using wrench then remove drive belt.
8. Remove PCV hose from cylinder block.
9. Remove intake duct stay from cylinder head.
10. Remove two bolts for remove ignition cable cover from cylinder head cover.
11. Disconnect ignition cable from ignition plug.
12. Disconnect camshaft position sensor harness and crankshaft angle sensor harness from behind generator.