Rodeo S 2WD L4-2.2L (1999)
13. Remove four bolts and remove the crankshaft pulley
14. Remove timing belt front cover.
15. Loose fixing bolt of timing belt rear cover then remove the camshaft angle sensor.
16. Remove ten cylinder head cover fixing bolts and remove the cylinder head cover.
INSTALLATION
1. Install the camshaft position sensor and tighten timing rear cover bolt.
Torque: 8 Nm (5.9 ft. lbs.)
2. Install the cylinder head cover and tighten bolts to the specified torque.
Torque: 8 Nm (5.9 ft. lbs.)
3. Install the timing belt front cover then tighten fixing bolts to the specified torque.
Torque: 6 Nm (4.4 ft. lbs.)
