Rodeo S 2WD L4-2.2L (1999)
4. Install the crankshaft pulley, tighten fixing bolts to the specified torque.
Torque: 20 Nm (14 ft. lbs.)
5. Move drive belt tensioner to loose side using wrench then install the drive belt to normal position.
6. Connect ignition cable to ignition plug.
7. Install ignition cable cover to cylinder head cover and tighten two bolt to the specified torque.
Torque: 3 Nm (2 ft. lbs.)
8. Install intake duct bracket to cylinder block.
9. Install PCV hose flange to cylinder block to the specified torque.
Torque: 25 Nm (18 ft. lbs.)
10. Connect cooling fan wire harness connector to cooling fan on left side top of fan shroud.
11. Connect left side ground cable to cylinder head cover and connect other side connector to left side wheel arch terminal.
Connect right side ground cable to generator stay and connect other side connector to right side wheel arch terminal.
12. Connect three(black, green and blue colors) engine wire harness connector to chassis harness of left rear side of engine compartment.
