Stylus L4-1588cc 1.6L DOHC (4XE1-W) (1991)
/Page-942005.png)
10.
Make sure that all springs and other components are in their proper place (Figure 6). If the buckle assembly is contaminated with dirt or other
residue, clean it with suitable cleaning products, then dry it thoroughly using compressed air (40 PSI maximum).
IMPORTANT!
When using compressed air be sure to wear proper eye protection to prevent injury. Take extreme care blowing compressed air around the spring
holder (Figure 6). The two button springs mounted on the spring holder rails can easily slide off or eject from the rails. If this happens and a button
spring is lost, the buckle assembly becomes inoperative. Call the Isuzu Care Team Line immediately at 1-800-666-3411 for further instructions.
11.
Insert the new release button into the buckle assembly. Press the release button and attach the latch spring using a small screwdriver (Figure 7).
12.
Make sure that the release button operates properly and the latch spring is attached correctly.
13.
Install the new upper cover to the buckle assembly.
