Commander 4WD V8-4.7L VIN N (2006)
6. Install the eight screws (5) that secure the two halves of the air distribution housing (3) together. Tighten the screws to 2.2 N.m (20 in. lbs.).
7. Install the four metal clips (4) that secure the two halves of the air distribution housing together.
8. Inspect the foam seal (1), especially at the parting line (2). If the seal is deformed or damaged, it must be replaced.
9. On LHD models, carefully install the heater core (3) into the right side of the air distribution housing (2).
10. If equipped with dual zone heating-A/C, install the blend door stop (1) onto the right side of the air distribution housing.
11. Position the rear floor/console door actuator (2) onto the right side of the air distribution housing (3). If necessary, rotate the actuator slightly to
