Sportage 4WD 2Dr L4-2.0L (2002)
18. Separate the two halves of the blower housing unit, exposing the evaporator and blower motor.
19. Remove the thermostat probe clips from the evaporation core and remove the thermostat probe from the evaporator core.
20. Remove the evaporator core from the bottom section of the blower housing unit.
21. Remove the C-clip retaining the fan wheel on the blower motor shaft.
22. Remove the fan wheel from the blower motor.
Assembly
1. Position the evaporator into the bottom half of the blower housing unit.
2. Install the seal around the evaporator.
