Sportage 4WD 2Dr L4-2.0L (2002)
3. Assemble the two halves of the blower housing unit together.
4. Fasten the two halves in place with eleven retaining clips.
5. Install the fan wheel on the blower motor shaft.
6. Insert the C-clip to retain the fan wheel on the blower motor shaft.
7. Attach the two wire connectors to the thermostat. (BRN wire on the left, BLU/WHT wire on the right.)
8. Install the blower motor into the blower housing unit.
9. Insert three screws to hold the blower motor in place.
Tighten the three screws to 62 lb-in (7 N.m).
10. Attach the connector to the blower motor.
