Freelander Service Procedures
ENGINE MANAGEMENT SYSTEM - SIEMENS
18-3-14 REPAIRS
5. Release throttle pedal switch from bracket on
throttle pedal assembly.
6. Release clips securing switch bracket to pedal
assembly and remove bracket.
Refit
1. Fit switch bracket to throttle pedal assembly
and secure with clips
2. Position switch and push fully into bracket on
pedal assembly.
3. To correctly position throttle pedal switch, move
throttle pedal to the closed position and ensure
that switch is in contact with tang on throttle
pedal.
4. Connect multiplug to throttle pedal switch.
5. Connect throttle inner cable to throttle pedal
and secure with clip.
6. Position throttle pedal assembly to bulkhead, fit
and tighten nuts to 25 Nm (18 lbf.ft).
Sensor - combined - manifold absolute
pressure/Intake air temperature (MAP/
IAT)
$% 19.22.26
Remove
1. Disconnect battery earth lead.
2. Remove engine acoustic cover.
ENGINE - K SERIES KV6, REPAIRS,
3. Disconnect multiplug from MAP/IAT sensor.
4. Remove 2 screws securing MAP/IAT sensor to
inlet manifold chamber, remove sensor.
Refit
1. Clean MAP/IAT sensor and mating face on inlet
manifold chamber.
2. Position MAP/IAT sensor, fit and tighten
screws.
3. Connect multiplug to MAP/IAT sensor.
4. Fit engine acoustic cover.
ENGINE - K SERIES KV6, REPAIRS,
5. Connect battery earth lead.
M19 3182
M19 3197