Freelander Service Procedures
ENGINE MANAGEMENT SYSTEM - SIEMENS
REPAIRS 18-3-15
Sensor - throttle position (TP) - NAS - up
to 03MY
$% 19.22.49
Remove
1. Disconnect battery earth lead.
2. Remove 2 nuts and release throttle pedal from
studs.
3. Release TP sensor multiplug from bracket and
disconnect from main harness.
4. Remove nut and release lever from sensor.
5. Remove 2 nuts and bolts and remove sensor.
Refit
1. Fit TP sensor and tighten nuts and bolts to 10
Nm (7 lbf.ft).
2. With throttle pedal held closed, fit lever to
sensor and tighten nut to 10 Nm (7 lbf.ft).
3. Position throttle pedal, connect multiplug and
secure to pedal bracket.
4. Fit pedal to studs and tighten nuts to 25 Nm (18
lbf.ft).
5. Connect battery earth lead.
6. Use TestBook/T4 to confirm correct operation.
