L322 Range Rover Service Procedures
PANEL REPAIRS
-20
REPAIRS
Bonnet locking platform
The bonnet locking platform is bolted in position,
there are no welds to hold it in place.
Remove
1. Remove both headlamp assemblies.
2. Remove LH and RH bonnet locks.
3. Diesel models: Remove fuel cooler air duct.
4. Remove 3 screws securing grille to bonnet
locking platform.
5. Remove bolts securing bonnet locking platform
and remove platform.
Refit
1. Position bonnet locking platform, align to
correct position, fit and tighten bolts.
2. Fit grille and secure with screws.
3. Diesel models: Fit fuel cooler air duct.
4. Fit LH and RH bonnet locks.
5. Fit both headlamp assemblies.
Headlamp mounting panel
The headlamp mounting panels are bolted in
position, there are no welds to hold them in place.
Remove
1. Remove both headlamp assemblies.
2. Remove LH and RH bonnet locks.
3. Diesel models: Remove fuel cooler air duct.
4. Remove 3 screws securing grille to bonnet
locking platform.
5. Remove bolts securing bonnet locking platform
and remove platform.
6. LH side: Remove horn.
7. LH side: Remove air intake hose.
8. RH side: Remove front bumper RH support
bracket.
9. RH side: Remove windscreen washer
Reservoir - combined windscreen/
headlamp washer.
10. RH side: Remove PAS fluid cooler.
STEERING, REPAIRS, Oil cooler -
Repair
1. Remove existing panel(s), prepare panel joint
faces and install new panel(s) in accordance
with Panel Replacement Procedure.
Refit
1. RH side: Fit PAS fluid cooler.
STEERING, REPAIRS, Oil cooler -
2. RH side: Fit windscreen washer reservoir.
Reservoir - combined windscreen/
headlamp washer.
3. RH side: Fit front bumper RH support bracket.
4. LH side: Fit horn.
5. LH side: Fit air intake hose.
6. Fit and tighten bolts securing bonnet locking
platform.
7. Fit 3 screws securing grille to bonnet locking
platform.
8. Diesel models: Fit fuel cooler air duct.
9. Fit LH and RH bonnet locks.
10. Fit both headlamp assemblies.
