GS 350 RWD V6-3.5L (2GR-FSE) (2007)
2. REMOVE STEERING COLUMN ASSEMBLY (for 3UZ-FE)
HINT:
Refer to the instructions for removal of the steering column assembly (3UZ-FE).
3. REMOVE STEERING LOCK ACTUATOR ASSEMBLY
(a)
Using a center punch, mark the center of the 2 tapered-head bolts.
(b) Using a 3 to 4 mm (0.12 to 0.16 in.) drill, drill a hole in the 2 bolts.
(c)
Using a screw extractor, remove the 2 bolts and steering lock actuator assembly from the steering column assembly.
4. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU
(a)
Disconnect the connector form the multiplex tilt and telescopic ECU.
(b) Using a screwdriver, remove the 2 screws and multiplex tilt and telescopic ECU.
INSTALLATION
1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
(a)
Using a socket wrench (+), install the multiplex tilt and telescopic ECU with the 2 screws.
Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf)
(b) Connect the connector to the multiplex tilt and telescopic ECU.