6 L4-2.5L (2010)
Tightening procedure
-
96-104 Nm {9.8-10 kgf-m, 71-76 ft-lbf}
-
87-93°
6. Remove the bolt (M6 X 1.0) installed to the crankshaft pulley.
7. Remove the SST from the camshaft.
8. Remove the SST from the cylinder block lower blind plug hole.
9. Rotate the crankshaft clockwise two turns and inspect the valve timing.
-
If not aligned, loosen the crankshaft pulley lock bolt and repeat from Step 1.
10. Install the cylinder block lower blind plug.
Tightening torque
-
18-22 Nm {1.9-2.2 kgf-m, 14-16 ft-lbf}
Cylinder Head Cover Installation Note
CAUTION:
-
Install the cylinder head cover before the applied silicone sealant starts to harden.
1. Apply silicone sealant to the mating faces as shown.
Thickness
-
4.0-6.0 mm {0.16-0.23 in}
2. Install the cylinder head cover with a new gasket.
3. Tighten the bolts in the order shown.
Tightening torque
-
8.0-9.5 Nm {82-96 kgf-cm, 71-84 in-lbf}
