6 L4-2.5L (2010)
On-Vehicle Installation
CAUTION:
-
When installing the control valve body component, do not put the coupler component in the open space of the separate plate in the control valve
body component.
-
Do not pinch the coupler component between the separate plate and the control valve body component.
1. Connect the manual valve link and install the control valve body component.
2. Temporarily install the control valve body component with the bolts.
Bolt length (measured from below the head)
-
A: 31 mm {1.220 in}
-
B: 17 mm {0.669 in}
-
C: 21 mm {0.827 in}
NOTE:
-
Aligning the bolt holes, temporarily tighten the bolt by hand.
3. Temporarily install the suction cover and a new gasket with the bolts.
