Milan FWD V6-3.0L (2010)
-
Separate the wire harness from the cushion side shield, if equipped.
2. Remove the side shield and any remaining side shield retainers from the seat and discard.
-
For installation, install a new cushion side shield (includes new retainers attached).
4. Remove the RH recliner outboard cover retainer cover.
5. Pull the head of the RH recliner outboard cover retainer up to release, then remove the retainer.
6. Remove the RH recliner outboard cover in the following sequence.
1. Pull out on the RH recliner outboard cover at the front and rear to release the cover retainers and at the bottom, pull the cover away from the
recliner.
2. Slide the RH recliner outboard cover back to separate from the recliner.
7. Route out the side air bag wire harness and remove the RH recliner outboard cover.
8. Separate the cable at the RH recliner in the following sequence.
1. Release the cable housing from the RH recliner.
2. Separate the cable from the RH recliner.
