Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
10. Measure the thickness of the 3-4 clutch internal spline clutch plate facing. The standard thickness is 1.6 mm (0.063 inch), with a wear limit of 1.4
mm (0.055 inch) .
11. If a 3-4 clutch internal spline clutch plate facing is not within specifications, replace the 3-4 clutch internal spline clutch plates as a set.
12. Ensure that the check ball is not stuck.
a. Apply compressed air to the check ball hole opposite the return spring. There should be no air leakage.
b. Apply compressed air to the check ball oil hole on the return spring side. Air should leak past the check ball.
13. Use a feeler gauge to measure the clearance between the oil distributor sleeve seal and the ring groove.
14. The oil distributor sleeve seal side clearance should measure 0.08-0.23 mm (0.0031-0.0091 inch). If the oil distributor sleeve seal side clearance
is above specification, replace the 3-4 clutch drum and input shaft.
ASSEMBLY
