Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
4. Use a hydraulic press and Bridge (part of T78P-3504-B) to compress the 3-4 clutch piston return springs and remove the 3-4 clutch snap ring.
5. Remove the clutch piston spring retainer and the 3-4 clutch piston return springs.
6. Remove the 3-4 clutch piston from the 3-4 clutch drum and input shaft by turning the 3-4 clutch piston.
7. Remove the 3-4 clutch D-ring and 3-4 clutch oil seal from the 3-4 clutch piston. Discard the 3-4 clutch D-ring and 3-4 clutch oil seal.
8. Check the components for deformation, fatigue, or damage. Replace if necessary.
NOTE: When replacing a 3-4 clutch piston spring retainer or return springs, replace them as a set.
9. Check the facing of the 3-4 clutch internal spline clutch plates for burns, cracks and damage.