Montero Endeavor 4WD V6-3.5L SOHC (2000)
<B> FRONT IMPACT SENSOR (R.H.)/FRONT IMPACT SENSOR (L.H.) REMOVAL
1. Slide the connector (green section) to release the lock.
2. Push down the pawl, and then disconnect the connector.
INSTALLATION SERVICE POINTS
<A> PRE-INSTALLATION INSPECTION
To mount the new front impact sensor, visually check it and measure the resistance between the terminals.
<B> FRONT IMPACT SENSOR (L.H.)/FRONT IMPACT SENSOR (R.H.) INSTALLATION
1. Securely connect the connector.
2. Position the front impact sensor facing toward the front of the vehicle as shown by the arrow in the illustration, and install it securely.
CAUTION: The SRS may not activate properly if a front impact sensor is not installed properly, which could result in the SRS system not operating
properly during a collision.
<C> POST-INSTALLATION INSPECTION
Reconnect the negative battery terminal. Turn the ignition key to the "ON" position. Does the "SRS" warning light illuminate for about 7 seconds, turn
off and then remain off for at least 45 seconds? If yes, SRS system is functioning properly. If no, refer to troubleshooting.
