Montero Sport V6-3.5L SOHC (2004)
STEP 17. Check harness wire between ETACS-ECU connector D-11 (terminal No.2) and fusible link number 8.
NOTE: After checking junction block connector D-01 and IOD storage connector A-54X, check the wires. If junction block connector D-01 and IOD
storage connector A-54X are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Is the harness wire between ETACS-ECU connector D-11 (terminal No.2) and fusible link number 8?
YES: Go to Step 18.
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 18. Measure the voltage at the input signal from the column switch (lighting switch).
1. Remove the ETACS-ECU and measure at the junction block side (connector D-11).
2. Turn the lighting switch on ("TAIL" or "HEAD" position).
3. Measure the voltage between terminal number 5 and body ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Check that the malfunction eliminated.
NO: Go to Step 19.
