Versa L4-1.6L (HR16DE) (2010)
Brake Rotor/Disc: Service and Repair
FRONT DISC BRAKE
Disassembly and Assembly of Brake Caliper Assembly
DISASSEMBLY
1. Remove the caliper assembly. See: Brake Caliper/Service and Repair/Removal and Replacement.
2. Remove sliding pin bolts and remove cylinder body from the torque member. Remove pads, shims, pad return spring
(AD22VK) and pad retainers from torque member as necessary.
CAUTION:
When removing pad retainer from torque member, lift the pad retainer in the direction shown by arrow, so as not to deform it.
3. Remove sliding pins and sliding pin boots from torque member.
4. Place a wooden block as shown, and blow air from union bolt mounting hole to remove piston and piston boot.
CAUTION:
Do not get fingers caught in the piston.
5. Remove piston seal with a flat-bladed screwdriver.
CAUTION:
Be careful not to damage the inner wall of cylinder.
INSPECTION AFTER DISASSEMBLY
Cylinder Body
Check the inner wall of cylinder for corrosion, wear, and damage. Replace cylinder body as necessary.