Aurora V6-214 3.5L VIN H SFI (2001)
1. Place the new small boot clamp (2) onto the small end of the joint boot (1). Slide the joint boot (1) and the small boot clamp (2) onto the halfshaft
bar.
2. Position the small end of the joint boot (1) into the joint boot groove (3) on the halfshaft bar.
3. Mount J41048 in a vise and proceed as follows:
3.1.
Position the outboard end (1) of the halfshaft assembly in tool J41048.
3.2.
Align the top of boot neck on the bottom die using the indicator.
3.3.
Place the top half of the J 41048 on the lower half of the J 41048.
3.4.
Before proceeding, ensure there are no pinch points on the halfshaft inboard boot. This could cause damage to the halfshaft inboard boot.
3.5.
Insert the bolts (2).
3.6.
Tighten the bolts by hand until snug.
4. Align the following items:
^
The halfshaft inboard boot (1)
^
The housing
^
The swage ring (2)
Tighten each bolt of J41048 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
