GTO V8-6.0L VIN U (2005)
7. If you separated the knuckle from the strut, install the 2 NEW bolts (2,3), the 2 washers (4,7), and the 2 NEW nuts (5,6).
1. Tighten the nuts to 85 Nm (63 ft. lbs.).
2. Tighten the nuts to 100 Nm (74 ft. lbs.).
3. Use the J45059 in order to tighten the nuts an additional 90 degrees.
8. Install the front brake rotor.
9. If you replaced the hub, measure the assembled lateral runout (LRO) of the brake rotor in order to ensure optimum performance of the disc brakes.
10. If the brake rotor assembled LRO measurement exceeds the specification, adjust the LRO to the specification.
11. Install the tire and wheel assembly.
12. Lower the vehicle.
