911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Air Bag: Service and Repair
Removing and Installing Airbag Triggering Unit
WARNING: The airbag triggering unit must not be removed with the connector remaining connected. When working on the airbag system,
allow a waiting time of at least one minute after switching off the ignition (disconnecting the battery) and removing the connector.
The triggering unit is located on the transverse wall above the center console.
1. Disconnect battery and cover terminal or battery.
2. Working from the passenger side, flip clamp open. Pull connector off the triggering unit.
3. Undo shear nut with Special Tool 9259.
4. Working from the driver's side, undo both shear nuts with Special Tool 9259 and take out triggering unit.
NOTE: The mounting locations on the body panel must be cleaned down to bare metal. Use 1/4 in. hex socket wrench to tighten the shear nuts.