911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Removing/fitting parking-brake cable
1. Disengage parking-brake cable at the parking-brake lever.
^
Release the parking-brake lever (do not operate again until fitting is complete; self-adjusting).
^
Open cover of oddments tray in center console.
^
Remove bottom of oddments tray in center console.
^
Remove the relevant parking-brake cable sideways out of the turnbuckle.
2. Open safety clip on combination plug connection -1- and detach the connector. Dismantle the combination plug connection -1- at the wheel
bearing housing.
Remove line for brake pad wear indicator from support on wheel carrier.
Loosen fastening screw -2- and remove the speed sensor.
Combination plug connection/speed sensor
3. Loosen the drive shaft at the transmission and wheel bearing housing (only at the wheel bearing housing if the wheel bearing or wheel bearing
housing needs to be replaced).
Drive shaft