Boxster S (987) F6-3.4L (2008)
Installing rear apron
1. Before installing the rear apron, the following steps must be carried out:
1.1. Check heat shields on the vehicle and replace them if necessary. Refer to Removing and installing rear bumper
1.2. Check position of rear lid and re-adjust it if necessary. Refer to Adjusting rear lid
1.3. Check position of rear retaining strip and re-adjust it if necessary. Refer to Removing and installing rear retaining strip
1.4. Check mounting points (fastening nuts) for rear apron and replace them if necessary.
INFORMATION: Two persons are needed to disengage and engage the rear apron.
2. Position rear apron on the vehicle until the plug connection -1- can be connected -arrow-.
INFORMATION: Insert rear apron right and left into rail.
3. Position rear apron -1- fully on the vehicle -arrow-.
4. Engage retainer plate -3- in the square opening.