ION L4-2.2L VIN F (2004)
17. Install the heat shield and thru-bolt to the rear transmission mount. Hand-start the bolt. Do NOT tighten the bolt.
18. Install the thru-bolt to the front transmission mount. Hand-start the bolt. Do NOT tighten the bolt.
19. Tighten the transmission mount bolts in sequence.
20. Lower the vehicle.
21. Remove the engine support fixture.
22. Connect the EVAP purge hose to the purge solenoid.
Important: A small amount of denatured alcohol can be used as an assembly aid when installing the vacuum check valve. Do NOT use soap.
23. Connect the vacuum check valve (1) with hose (3) to the brake booster.
24. Connect the electrical connector to the park/neutral position switch.
25. Check to ensure that the master cylinder-to-vacuum brake booster seal (1) is properly seated into the recessed groove on the master cylinder.
