Leon Mk2
| Assembly overview - clutch release mechanism |
| 1 - | Release bearing |
| q | To remove and install, remove gearbox |
| q | Remove and install together with clutch release lever → Item and guide sleeve → Item → Fig. to → Fig. |
| q | Do not wash out bearing; wipe clean only |
| q | Renew noisy bearings |
| 2 - | Bolt, 5 Nm and tighten 90 º more |
| q | Always replace. |
| 3 - | Clutch release lever |
| q | To remove and install, remove gearbox |
| q | Remove and install together with clutch release collar → Item and guide sleeve → Item → Fig. to → Fig. |
| q | Remove existing grease |
| 4 - | Retaining spring |
| q | To remove and install, remove gearbox |
| q | Secure to clutch release lever |
| 5 - | Guide sleeve |
| q | To remove and install, remove gearbox |
| q | Removing and installing together with clutch release collar → Item and clutch release lever → Item → Fig. to the → Fig. |
| 6 - | Ball head stud, 20 Nm |
| q | To remove and install, remove gearbox |
| q | Remove old grease from contact surface of clutch release lever |
| q | Lubricate with grease -G 000 100- |
| 7 - | Join ring for the input shaft |
| q | replace → Chapter |
| 8 - | Gearbox |
| 9 - | Hexagon bolt, 20 Nm |
| 10 - | Slave cylinder |
| q | Removing and installing → Chapter>>>>>>>> |
