Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk201 · Power transmission
01 · Transmission

Renewing gear oil

Make
SEAT
Model
Leon Mk2
Section
7-speed dual clutch gearbox 0AM › Gearbox mechanics,operation, construction,diff. › Renewing gear oil
Power transmissionRenewing gear oil
Renewing gear oil
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
   
Renewing gear oil – SEAT Leon Mk2
Special tools and workshop equipment required
t  Extractor -SAT 1100-, see equivalent → Anchor
t  Torque wrench kit -SAT 8010-, see equivalent → Anchor
t  Adapter for oil filling -VAS 6262 A- with -VAS 6262/4-

Renewing gear oil – SEAT Leon Mk2  Note
t  Observe rules for cleanliness when working on gearbox → Chapter.
t  Refer to general repair instructions → Chapter.
t  Observe notes on gearbox, disposing of oil → Chapter.
The gearbox is filled for life.
It is not possible to check the oil level on this gearbox.
If the gearbox is leaking, trace the cause of the leak and repair as required.
Then the gearbox oil must be completely drained off and the gearbox filled with new gear oil.
Conditions
l  Engine off.
l  Shift selector lever into position „P“.
   
Operation process
–  Remove the centre sound insulation → Bodywork, exterior installation work; Rep. gr.50
–  Fit the tray oil extractor -SAT 1100- beneath gearbox.
  A34-10532
–  Remove oil drain plug -arrow- from gearbox.
–  Allow the gear oil to drain out.
–  First repair this leak.
–  Fit drain plug.
When the gearbox is fitted, the battery must be removed to fill with oil.
Renewing gear oil – SEAT Leon Mk2   Caution
When disconnecting the battery there is a risk of serious damage to electronic components:
Observe the correct procedure for disconnecting the battery → Rep. gr.27.
  N34-11371
–  Remove battery → Electrical system; Rep. gr.27 .
–  Put the gear selector lever into position „P“.
–  Remove the air cleaner housing → Injection and ignition system ; Rep. gr.24.
  E34-10141
–  Remove the cap of the bleeder -arrow-, that is located next to the lever for the selector shaft.
Renewing gear oil – SEAT Leon Mk2  Note
For illustration purposes, the installation position is shown with the gearbox removed.
Renewing gear oil – SEAT Leon Mk2   Caution
Risk of damage to the gearbox.
The adapter for the oil filling -VAS 6262 A- with -VAS 6262/4- must be clean. The gear oil should not be mixed with other oils!
  A37-11078
–  Screw the gearbox oil filling bottle for 7-speed dual clutch gearbox onto the adapter for the oil filling -VAS 6262 A-. Part number → Electronic parts catalogue.
–  Position the filling bottle so that no oil can enter the filling hose.
  A37-11079
–  Connect the adapter -VAS 6262/4- to the filling hose and fit to the bleeder to the gearbox.
–  Turn over the filling bottle and fill the amount required. Capacity: 1.7 litres of oil.
Do not fill any more or any less oil. Malfunctions would result!
  N34-11773
–  Remove the adapter -VAS 6262/4- and fit the cap onto the bleeder -arrow-.
–  If removed, reinstall the air filter housing → Injection and ignition system ; Rep. gr.24.
  A37-11078

The same page in: Leon Mk1.

Parts & tools for this job For SEAT Leon

As an Amazon Associate we earn from qualifying purchases.