seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Check the activation signal for the Compressor regulation valve, air conditioning N280 > < Removing the holder

Leon Mk2

Install the holder
Install the holder
Installation is carried out in the reverse sequence; note the following:
   
–  Before fitting the compressor, check the correct positioning of the two sleeves -arrow- on the support or on the compressor.
  A87-0634
–  Fit accordingly, a washer on the attachment bolts -arrows- (torque 25 Nm).
–  Check carefully following fitting of the compressor, the secure fitting of the refrigerant tubes. They must be secured in the supports designed for them (depending on the engine type).
–  After attaching the compressor, also check the refrigerant pipes and corresponding holders to ensure adequate clearance from other components. Also ensure that there is sufficient space between the belt, the support and the pulley.
  A10-1637

Check the activation signal for the Compressor regulation valve, air conditioning N280 > < Removing the holder