seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Refitting > < Clutch pedal: removing and refitting

Leon Mk2

Removing
Removing
  Note!
To carry out this operation, the ground cable must be disconnected from the battery. It is best to check first whether there is a coded radio fitted, if so, check the security code beforehand.
–  Disconnect the ground from the battery.
–  Remove the lower linings from the steering column and the light switch.
–  Remove the packet holder and the footrest area from the driver side. → Bodywork, fitting work, interior; Rep. Gr.68
   
–  Remove the bolts holding the fuse holder and move upwards -arrow 1-.
–  Disconnect the cable harness and pull down -arrow 2-.
–  Tension the clutch cable and remove from the gearbox → Chapter.
–  Extract the connector of the brake light switch and release the cable from the fixing clip on the pedal unit.
  N30-0244
–  Remove the protective plate of the pedal unit located next to the electrical connector support. Free the lip -1- and lift the plate upwards and out.
  E30-0018
–  Cut the plastic flange holding the clutch cable to the pedal and release the cable -arrow-.
  V30-0397
–  Extract the hexagonal bolt from the pedal shaft -1-.
–  Carefully pull out the pedal shaft -arrow 2-. At the same time fix the brake pedal in position with an M8 bolt or a punch on the right side -arrow 1-.
  Note!
Do not move the brake pedal or the steering column, which are loose once the pedal shaft has been removed.
–  Remove the clutch pedal.
  N30-0082

Refitting > < Clutch pedal: removing and refitting