seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Tightening exhaust temperature sender 3G495 > < Particle filter with primary exhaust pipe - Assembly overview

Leon Mk2

Tightening exhaust temperature sender 4G648
Tightening exhaust temperature sender 4 -G648-
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Adjustment tool -T100395-, see equivalent → Anchor
  W00-10767
t  Torque wrench -VAG 1331-, see equivalent → Anchor.
Lubricate thread of sender using high-temperature paste -G 052 112 A3-.
  W00-0427
–  Screw exhaust temperature sender 4 -G648- in by hand.
  Note
The figure may differ from the actual situation. The arrangement of the wrenches/spanners is correct.
–  After this, tighten sender with a torque wrench and the spanner -T10395/6-.
  Caution
The torque wrench must be set to 29 Nm in this case.
The „extension“ of the torque wrench with the spanner-T10395/6- allows the correct torque of 45 Nm to be achieved.
  N26-10518

Tightening exhaust temperature sender 3G495 > < Particle filter with primary exhaust pipe - Assembly overview