seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing sump

Leon Mk2

Removing
Removing
–  Removing centre and right insulation tray → General Body Repairs; Rep. Gr.50.
–  Drain engine oil.
   
–  Unbolt oil return pipe -1- from sump.
–  Remove sump.
  Note!
Loosen and tighten sump bolts with jointed spanner -U-30013-. Use socket set -U-40051- to remove the bolts.
–  Remove sump, it may be necessary to release sump by tapping lightly with a rubber head hammer.
–  Remove sealant residue on cylinder block with a flat scraper.
  E17-0012
–  Remove sealant residue on the sump with a rotating brush, e.g. a hand drill with a plastic brush (wear protective glasses).
–  Clean sealing surface, must be free of oil and grease.
  N17-0012

Installing > < Removing and installing sump