| Cooling system: removing and fitting. |
Note | t
| The cooling system is under pressure when the engine is warm. Therefore, this pressure must de reduced before repairing. |
| t
| Hose connections are secured with spring clamps. Always use spring clips when performing repairs. |
| t
| For fitting spring-type clips, it is advisable to use retention tool -T20174- or pliers -T20029-. |
| t
| When fitting, route coolant hoses without tension and not touching other components (note marking on coolant connection and hose). |
| Perform cooling system leakage check with tester -SAT 1274- and adaptor -VAG 1274/8- and adaptor -VAG 1274/9-. |
| Bodywork side cooling system components → Chapter. |
| Engine side cooling system components → Chapter. |
| Diagram of coolant hose connections → Chapter. |
|
|
|
