SEAT Workshop Service and Repair Manuals

Coolant temperature sender -G62-: Removing and installing t  Removing → Anchor. t  Fitting → Anchor. Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Release lever -80 - 200-, see equivalent → Anchor

Removing . l  Engine cold. –  Open filler cap on coolant expansion tank briefly and allow residual pressure in cooling system to dissipate.

–  Remove the engine cover upwards -arrows-.

–  Remove centre noise insulation -fastening points 1 ... 3-. –  Remove air filter housing → Chapter.

–  Unscrew bolts -arrows-. –  Free electrical lines and hoses on left air pipe using removal lever -80 - 200-. –  Loosen hose clip -3- and press left air pipe with coolant pipe aside.   Note Disregard items -1-, -2-, -4- and -5-.

–  Pull connector -4- off coolant temperature sender -G62-.   Note Place a cloth underneath union to catch escaping coolant. –  Pull off retaining clip -3- and pull coolant temperature sender -G62- out of screw connection.   Note Ignore items -1- and -2-. Fitting . Installation is carried out in reverse order, noting the following:   Note t  Renew O-ring. t  Insert new coolant temperature sender -G62- immediately into union to avoid loss of coolant. –  Check coolant level and top up if necessary → Chapter.