seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Throttle valve control unitJ338: cleaning > < Removing and installing fuel pressure senderG247

Leon Mk2

Removing and installing throttle valve moduleJ338
Removing and installing throttle valve module -J338-
Removing:
   
–  Release hose clip -2-.
–  Remove bolt -4-.
–  Unplug electrical connector -arrow-.
–  Remove the sound insulation → Bodywork, exterior installation work; Rep. gr.50
  A21-10161
–  Remove charge air hose -A- and seal charge air cooler with a clean cloth.
  N15-10703
–  Remove bolt -1- and take out air pipe downwards.
  A21-10161
–  Disconnect electrical connection -1- on throttle valve control unit -J338-.
–  Unscrew bolts -arrows- and remove throttle valve module -J338-.
Installing:
Installation is carried out in the reverse order; noting the following in the process:
Tightening torques → Chapter
–  Clean the sealing surface for O-ring.
–  Renew gasket, making sure that service lug is correctly positioned on oil seal.
–  If a new throttle valve module -J338- was installed, adapt engine control unit to throttle valve module -J338- using a → vehicle diagnosis tester in „Guided functions“.
  A24-10398

Throttle valve control unitJ338: cleaning > < Removing and installing fuel pressure senderG247